Borescope Guide Tube Options
We offer several different guide tube options, depending on your specific application. These work with both the VJ-3 and the VJ-4 borescopes.
Borescope Guide Tube Options
Guide tubes are used to direct the articulating borescope to the specified area that is needed to inspect. Even with guide tubes, care is needed so as to not damage or bend the borescope into an incorrect position. We recommend that you keep your borescope guide tube in the case or in a clean and safe place as to avoid damage or contamination from entering the tube itself. In some cases, we can offer the borescope guide tube in connection with a borescope purchase.
Pratt & Whitney guide tubes are used to inspect engines with the VJ-3 or VJ-4 3.9mm borescopes.
PWC 200 – Guide Tube
PWC 400 – Guide Tube
PWC 600 – Guide Tube
Synflex Semi-flexible tubing can be cut to any length and used to form custom application tubes for those “hard to reach” applications. Works with VJ-3 or VJ-4 borescopes.
SYNFLEX 1/4″ FOR
2.2mm & 2.8mm Borescopes
SYNFLEX 3/8″ FOR
3.9mm Borescopes
SYNFLEX 1/2″ FOR
6.0mm Borescopes
Rigidizers/grabbers are used to keep the insertion tube elevated over open spaces, in order to reach your target inspection area. Works with VJ-3 or VJ-4 borescopes.
RIGIDIZER/GRABBER FOR
6.0mm Borescopes
RIGIDIZER/GRABBER FOR
3.9mm Borescopes
Request a Free Demo Unit
Check the box in the form below and one of our representatives will arrange a free demo unit.
Call Us at 231-943-1171
– Or –
Fill out the form below and one of our representatives will contact you.